Wavetronix Click 421 (bluetooth to serial converter) (CLK-421 User Manual download pdf

Click 421 Serial to Bluetooth®

INSTALLER QUICK-REFERENCE GUIDE

Wire power and communication

If you are using a Click 200 surge protector with the Click 421, power and communication are provided to

the Click 421 through the T-bus (see the Click 200 Quick-reference Guide). If you don’t have a Click 200

surge protector, use the following steps to wire power and communication into the Click 421:

1 Plug a T-bus 5-screw terminal block into the rst T-bus connector.

2 Wire DC power (9–28 V) from the power supply into the rst screw terminal on the 5-screw terminal

block; wire -DC into the second screw terminal.

3 Connect RS-485 communication (+485, -485 and GND) to either the remaining three screw terminals

on the 5-screw terminal block or to the

screw terminals in the pluggable screw

terminal block on the top of the Click 421

(see labels for correct wiring).

e front of the Click 421 has one other com-

munication port.

˽ DB-9 connector – Connect a straight-

through cable here for RS-232 communica-

tion

www.wavetronix.com

801.734.7200

Mount the device

e Click 421 mounts over a T-bus for power and communication:

1 If the Click 421 was shipped with the T-bus connector attached, re-

move the connector from the module.

2 Snap the connector onto the DIN rail by positioning it over the rail

with the male connector pointing to the right. Hook one arm over the

edge of the DIN rail and press down on the other arm until it snaps

into place.

3 Connect the T-bus connector to the rest of the T-bus by sliding them

together until you hear them snap into place.

4 Mount the Click 421 onto the DIN rail: position it properly over the

T-bus connector, hook the lip over the lower edge of the DIN rail, and

use a rocking motion to snap the module into place.

1 2 3 4

Summary of Contents

Page 1 - Mount the device

Click 421 Serial to Bluetooth®INSTALLER QUICK-REFERENCE GUIDE2 Wire power and communicationIf you are using a Click 200 surge protector with the Click

Page 2 - Attach the antenna

3 Attach the antennae Click 421 has a reversed polarity SMA antenna connector. A whip antenna can be used inside the cabinet, though if it is inside

Page 3

5 Connect via laptop or handheld computere Click 421 cannot initiate a connection; that must be done by a laptop or handheld computer with Bluetooth

Page 4 - Expert Driver (Bluetooth Tab)

Comments to this Manuals

No comments

Wavetronix Click 421 (bluetooth to serial converter) (CLK-421 User Manual

Browse online or download User Manual for Equipment Wavetronix Click 421 (bluetooth to serial converter) (CLK-421. Wavetronix Click 421 (bluetooth to serial converter) (CLK-421) - Quick-reference Guide User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for Equipment Wavetronix Click 421 (bluetooth to serial converter) (CLK-421