Wavetronix SmartSensor 105 (SS-105) - User Guide User Manual download pdf (Page 17)

16 CHAPTER 1  INSTALLING THE SMARTSENSOR 105

Applying Silicon Dielectric Compound

Use the following steps to correctly apply the silicon dielectric compound:

1 Tear the tab o the tube of silicon dielectric compound.

2 Squeeze about 25% of the silicon into the connector at the base of the SmartSensor as

shown in Figure 1.5. Be sure to wipe o any excess compound.

Figure 1.5 – Applying Silicon Dielectric Compound

Connecting the SmartSensor Cable

1 Attach the cable connector to the 25-pin connector at the base of the SmartSensor as

shown in Figure 1.6. e SmartSensor connector is keyed to ensure proper connection;

simply twist the connector clockwise until you hear it click into place.

2 Strap the cable to the pole or run it through a conduit to avoid undue movement from

wind and reduce cable strain.

Figure 1.6 – Attached Cable

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 98 99

No comments

Wavetronix SmartSensor 105 (SS-105) - User Guide User Manual Page 17