Wavetronix SmartSensor 105 (SS-105) - User Guide User Manual download pdf (Page 16)

CHAPTER 1  INSTALLING THE SMARTSENSOR 105 15

Figure 1.3 – Attaching the Sensor to the Mounting Bracket

Aligning the Sensor to the Roadway

Follow the steps below to correctly align the SmartSensor (see Figure 1.4):

Figure 1.4 – Aiming the SmartSensor

1 Aim the front of the sensor at the center of the detection area. You may also refer to

Figure 1.1 as an illustration of where to aim the sensor.

2 Adjust the side-to-side angle to within approximately ±2° of perpendicular to the ow

of trac.

3 Tighten mounting bracket bolts.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 98 99

SmartSensor 105 1
Contents 4
Introduction 6
SmartSensor 105 Package 7
Selecting a Mounting Location 7
In this chapter 12
Center Line 13
Figure 1.6 – Attached Cable 17
Connecting Power and 18
Surge Protection 2 18
Underground 19
Wiring to Earth Ground 21
Wiring AC Surge Protection 23
Connecting DC Power 25
In the Main Trac Cabinet 26
Wiring Communication 27
Using SmartSensor Manager 30
Manager 3 32
About Screen 33
Table of Contents 33
Figure 3.3 – Help Screen 34
Release Notes 35
Communication 4 36
Serial Connection 37
Advanced Serial Settings 38
Modem Connection 39
Internet Connection 40
Advanced Internet Settings 41
Firmware Upload 42
Exit SmartSensor Manager 43
Continue w/o upload 43
Connection Properties 44
Address Book 45
Using the Address Book 46
Communication Error 47
Sensor Settings 5 50
Sensor Settings 51
Figure 5.2 – General Tab 52
Communication Tab 53
Data Collection Tab 54
Sensor Date & Time 57
Operating Mode 58
Lane Setup 6 60
Edit Range Blinders 61
Manage Gain 62
Lane Conﬁguration – Manual 63
Paint and Remove Lines 64
Remove Lane 64
Construct and Remove Roads 64
Construct and Remove Barriers 65
Reverse Direction 65
Edit Lane Names 66
Saving the Conﬁguration 67
Undoing Manual Changes 67
Verifying Lane Conﬁguration 68
Trac (Event) Data 69
Figure 6.9 – Event Counter 70
Figure 6.10 – Event Log 70
Interval Data 71
Data Collection 7 74
Step 2: Conﬁgure the Sensor 76
Interval Data Buer Status 76
Data Download 77
Download Interval Data 78
Data Logs 79
Figure 7.4 – Export Data Logs 81
Tools 8 84
CHAPTER 8  TOOLS 85 86
Figure 8.2 – Firmware Upload 86
Controller 89
Contact Closures 90
Programming Contact Closures 91
Appendix 92
Brown CTS 93
Gray 232 GND 93
Appendix C – Cable Lengths 96

Comments to this Manuals

No comments

Wavetronix SmartSensor 105 (SS-105) - User Guide User Manual Page 16

Comments to this Manuals

Related products and manuals for Sensors Wavetronix SmartSensor 105 (SS-105) - User Guide