Wavetronix Command DataView (CMD-DV) - User Guide User Manual download pdf (Page 45)

44 CHAPTER 4  DATA PAGE

 Minimum Data Threshold/Minimum Source Threshold – ese values are used only

if the appropriate Factor Groups setting is chosen (see above). ese values are in hours.

When you have nished setting parameters, click the Calculate AADT/MADT values for

Selected Stations button. DataView will use the existing data to calculate the average an-

nual and monthly values for the selected stations, using parallel stations in the same factor

group as desired. Once nished, the new yearly entries for the selected stations will be

displayed in the list.

In cases where less than a full year’s worth of data is available for one or more stations,

DataView will calculate partial gures where applicable and put zeroes in months where

no data is available.

Adding AADT/MADT Values Manually

In cases where the AADT/MADT values for stations have already been calculated, they can

be entered manually into DataView without having to be recalculated using stored data.

To manually enter an AADT/MADT value, select one or more stations and open the Man-

ual Add menu at top. Fill in the values, including the year, and click Add Manual Record.

(Fields le blank will be recorded as a zero.) e manual record will be added to the list,

assigned to the station(s) that were selected.

Note

Each station may have only one AADT/MADT record per year. To replace a station’s

entry for a year, ﬁrst delete the existing entry using the Delete link, then either man-

ually add or recalculate the new values for that station.

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 105 106

No comments

Wavetronix Command DataView (CMD-DV) - User Guide User Manual Page 45