Wavetronix SmartSensor Advance Extended Range (SS-200E) - Use User Manual download pdf (Page 60)

CHAPTER 5  SENSOR SETTINGS 59

Note

The RF Channel drop-down list allows you to select whether the PGA starts at a value

of 7 or remains ﬁxed during the auto-conﬁguration process.

 Units – Allows you to display either English (mph/feet) or metric (kph/meters) units.

 Source – In normal use, the source is always the radar Antenna. However, in some

cases, other sources may be used for demonstrations or evaluations. When the source

is switched to Diagnostic, the antenna is no longer used. Instead, a predetermined se-

quence of trac will appear. is setting will always return to Antenna aer rebooting

the sensor.

Communication Tab

e Communication tab is used to specify baud rate and response delay for the sensor’s

RS-485 ports (see Figure 5.3).

Figure 5.3 – Communication Tab

e Communication tab contains the following settings:

 Baud Rate – is section allows you to set the baud rate for ports 1 and 2. e green

arrow indicates the communication link (Port) on which SSMA is connected. e de-

fault value is 9600 bps.

1 2 ... 55 56 57 58 59 60 61 62 63 64 65 ... 147 148

No comments

Wavetronix SmartSensor Advance Extended Range (SS-200E) - Use User Manual Page 60